16. G2d_m2m_pfc_it

16.1. Function description:

This demo shows how to trigger G2D CLUT transfer complete, watermark & transfer complete interrupt.

Convert the L8 to RGB888 output:

Enable global interrupt & register G2D interrupt.
Configure the G2D memory-to-memory with pixel format conversion mode.
Configure & load the G2D foreground CLUT, after the CLUT loading has been completed will triggger the CLUT transfer complete interrupt.
Enable the related interrupt, after the setted lines has been transformed and finish the transformation will trigger the watermark & transfer complete interrupt.
Configure the G2D foreground layer and start transfer.
Waiting trigger the related interrupt and enter interrupt service routine.

If successfully trigger and enter interrupt service routine, then print pass, if not print fail.

None