DDR200T Evaluation Kit

Overview

Nuclei have customized a FPGA evaluation board (called DDR200T Evaluation Kit), which can be programmed with HummingBird SoC FPGA bitstream.

DDR200T Evaluation Kit

DDR200T Evaluation Kit

Click DDR200T Evaluation Kit Board Documents to access the documents of this board.

Setup

Follow the guide in DDR200T Evaluation Kit Board Documents to setup the board, make sure the following items are set correctly:

  • Use Hummingbird debugger to connect the MCU-JTAG on board to your PC in order to download and debug programs and monitor the UART message.

  • Power on the Board using USB doggle.

  • The HummingBird SoC FPGA bitstream with HummingBird RISC-V evaluation core inside is programmed to this board.

  • Following steps in board user manual to setup JTAG drivers for your development environment

How to use

For DDR200T Evaluation board:

  • DOWNLOAD support all the modes list in DOWNLOAD

  • CORE support all the cores list in CORE

To run this application in HummingBird Evaluation board in HummingBird SDK, you just need to use this SOC and BOARD variables.

# Clean the application with DOWNLOAD=ilm CORE=e203
make SOC=hbirdv2 BOARD=ddr200t DOWNLOAD=ilm CORE=e203 clean
# Build the application with DOWNLOAD=ilm CORE=e203
make SOC=hbirdv2 BOARD=ddr200t DOWNLOAD=ilm CORE=e203 all
# Upload the application using openocd and gdb with DOWNLOAD=ilm CORE=e203
make SOC=hbirdv2 BOARD=ddr200t DOWNLOAD=ilm CORE=e203 upload
# Debug the application using openocd and gdb with DOWNLOAD=ilm CORE=e203
make SOC=hbirdv2 BOARD=ddr200t DOWNLOAD=ilm CORE=e203 debug

Note

  • You can change the value passed to CORE according to the HummingBird RISC-V Core the HummingBird SoC you have.

  • You can also change the value passed to DOWNLOAD to run program in different modes.

  • The FreeRTOS and UCOSII demos maybe not working in flashxip download mode in HummingBird board due to program running in Flash is really too slow. If you want to try these demos, please use ilm or flash download mode.