5. M2m_int

5.1. Function description:

This demo shows how to trigger full & half transfer interrupt.

The source & destination address is increasing automatically, and dma working in normal mode:

Enable global interrupt & register UDMA interrupt.
Enable full & half transfer interrupt.
Initialize & configure the udma.
Start dma data transfer.
Compare the data in destination address with the data in source address after triggering the full & half transfer interrupt and entering interrupt service routine.

Mode	Buffer size	Des address mode	Src address mode	Src width	Des width	Channel
normal	256 bytes	increasing	increasing	16 bits	16 bits	CH0

If successfully trigger and enter interrupt service routine, then print pass, if not print fail.

None