4. M2m_fixed_addr

4.1. Function description:

This demo shows memory to memory data transfer working in normal mode.

The source & destination address is fixed:

Enable global interrupt & register UDMA interrupt.
Enable full transfer interrupt.
Initialize & configure the udma.
Start dma data transfer.
Compare the data in destination address with the data in source address after trigger full interrupt.
Change the fixed address of source & destination to restart to verify the ccorrectness when working in fixed address mode.

Mode	Buffer size	Des address mode	Src address mode	Src width	Des width	Channel
normal	1 bytes	fixed	fixed	8 bits	8 bits	CH0

If the data writted to buffer by DMA is same as the source data, then print pass, if not print fail.

None