9. Singlepulse

9.1. Function description:

This demo shows how to configure the ADVANCED_TIMERn peripheral in single pulse mode. The external signal is connected to ADVANCED_TIMERn CH0 pin and the falling edge is used as active edge.then The single pulse signal is output on ADVANCED_TIMERn CH1 pin. The ADVANCED_TIMERnCLK frequency is set to systemcoreclock 8MHz,the prescaler is 8.

For instance:

ADVANCED_TIMERn counter clock is 1MHz.

Single pulse value = (ADVANCED_TIMERn_period - ADVANCED_TIMERn_pulse) / ADVANCED_TIMERn counter clock = (1500 - 500) / 1MHz = 1 ms.

9.2. Test result:

The output signal as the following description:

The channel 2 output single pulse

9.3. IO connection:

NONE

9.4. Output pad:

PAD
pad_ADVANCED_TIMERn_bkin
pad_ADVANCED_TIMERn_etr
pad_ADVANCED_TIMERn_ch1_i
pad_ADVANCED_TIMERn_ch2_i
pad_ADVANCED_TIMERn_ch3_i

Note

The ‘m’ and ‘n’ in “advtimer_timerm” and “advtimer_timern” indicate the peripheral number.